2010 Genesis Portable Spa
LTR20101058, Rev. B
Operating Your Spa
www.calspas.com
6
Electronic Control Operation
Initial Start up
When rst powered up, your spa will perform
a self-diagnostic check and go into priming
mode. When the control panel displays PR,
IMMEDIATELY do the following:
Press the JETS button to turn on the 1.
pump and let it run for 10 seconds. The
pump should be running in low speed.
Press the JETS buttons again and let the 2.
pump run in high speed for 10 seconds.
Press the JETS button again to turn off the pump. 3.
The pump should be left in the off position for 10
to 15 seconds.
Repeat steps 1 through 3 until water is owing 4.
through all the jets and all air is removed from the
plumbing.
When the spa has nished priming, the heater will be
activated and the water temperature will be maintained
in standard mode. The spa will heat to 100°F (37.5°C)
at start up until the set temperature is changed as
described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual wa-
ter temperature in degrees Fahrenheit. The displayed
temperature will only be current after the pump has
been running for at least two minutes.
To display the temperature that the spa is set to:
Press either the • Up or Down button. The tem-
perature setting will ash.
While the display is ashing, each time you press •
the Up or Down button, the set temperature will
change up or down one degree.
Standard, Economy and Sleep Heating
Modes
Your new spa is equipped with a heating feature that
gives you complete control of the heating system.
When the spa is powered up, it will automatically start
in standard heating mode.
St• will light briey on the main display. In this
mode, the heating system will automatically main-
tain the set spa temperature. In the economy-
heating mode, the heating system will only acti-
vate during ltration times.
Ec• will display solid if temperature is not current
and will alternate with spa temperature if mea-
sured temperature is current.
Economy mode will heat the water to the set tem-•
perature while Sleep mode, indicated by a SL on
the main display, will also only activate the heater
during the ltering cycles but will only heat the
water to within 20°F (10°C) of the set tempera-
ture. Like Economy mode, SL will display solid
when temperature is not current and will alternate
with actual temperature when it is current.
Switching Modes
Press either the • Up or Down button followed by
the Light button.
Press the same sequence to switch to the next •
mode.
Jets
Press the Jets button:
Once to activate low speed pump.•
Twice to activate high speed.•
Three times to turn pump off.•
Light
Press the Light button to turn on the light. Press it
once again to turn the light off. All optional lighting
such as the control panel light and cabinet perimeter
lighting is controlled by the Light button and will turn
on and off with the spa light.
Operating Your Spa