Cal Spas A826B Hot Tub User Manual


 
4
Portable Spa Site Preparation
Your spa needs a solid and level foundation. The area that it sits on must
be able to support the weight of the spa, with water and the occupants who
use it. If the foundation is inadequate, it may shift or settle after the spa
is in place, causing stress that could DAMAGE YOUR SPA SHELL AND
FINISH.
Note: Damage caused by inadequate or improper foundation support is
not covered by the warranty. It is the responsibility of the spa owner to
provide a proper foundation for the spa.
Place the spa on an elevated foundation (preferably a 3” - 4” concrete
slab). Pavers, gravel, brick, sand, timbers or dirt foundations are not
adequate to support the spa. If you are installing the spa indoors, pay
close attention to the ooring beneath it. Choose ooring that will not be
damaged or stained.
If you are installing your spa on an elevated wood deck or other structure, it
is highly recommended that you consult a structural engineer or contractor
to ensure the structure will support the weight of 150 pounds per square
foot.
To properly identify the weight of your new spa when full, remember water
weighs 8.33 lbs. per gallon. For example, an average 8’ spa spa holds
approximately 500 gallons of water. Using this formula, you will nd that
the weight of the water alone is 4,165 lbs. Combined with the dry weight
of the spa you will note that this spa will weigh approximately 5,000 lbs.
when full of water.
Note: It is strongly recommended that a qualied, licensed contractor
prepare the foundation for your spa.
Your Cal Spas
®
retailer can help you with your foundation and more. Your
retailer has a wealth of information and experience about how to get the
most out of your spa and can provide you with a full line of accessories
that are designed to complement your spa and increase your enjoyment.
In-Ground Spa Site Preparation
Ensure there is enough room for the spa and equipment.
The equipment pack must be located within a maximum of 15 feet
from the spa.
Plan for proper electrical and gas service to both the equipment area
and spa side.
Ensure the required at, level foundation can be constructed in the
area chosen.