Filter
Top Products
Page 24 2008 Portable Spa Owner’s Manual
LTR20081000, Rev. B
Water Quality Maintenance
Traditional Chemical Start Up
Prior to lling a spa for the rst time, or after a routine
draining, you will want to follow this start-up plan to
extend water life and performance. If you are following
either the Bromine or Chlorine Clear Water Plans, you
will notice that both start-up processes are the same with
the exception of Step 7. As with all chemical dosages
listed in these Clear Water Plans, start-up dosages are
intended for 500-gallon spas. Please adjust the chemical
dosages to the capacity of your particular spa.
Start Up
Clean surface of spa with Cal Spas “Multi-Purpose
Cleaner”.
Apply a protective coat of Cal Spas “Fast Sheen” to
the acrylic surface.
Fill spa to proper water level with normal tap water.
(Do not use soft water.)
Use test strip and balance the spa water.
Adjust total alkalinity (acceptable range is 80-
120ppm).
Adjust pH if necessary (between 7.2 to 7.8).
Pour in 16 oz of Cal Spas “Metal Protector” in the
center of the spa.
Add either bromine or chlorine (according to your
preferred plan).
Bromine: Add 2 oz of Cal Spas “Go Brom” to
establish a bromine base.
Add 2 Cal Spas “Bromine Tablets” to
bromine oater.
Set oater opening at #2.
Chlorine: Add two tablespoons of Cal Spas
“Chorine Granules” to the spa water.
Sprinkle 2 oz of Cal Spas “Oxidizer Shock” in the
center of the spa and turn on jets for 15 minutes.
Leave spa uncovered during this time.
Put cover on spa and allow to heat up to desired
temperature.
1.
2.
3.
4.
•
•
5.
6.
7.
8.
Bromine Clear Water Plan
This plan and its chemical dosages are intended for Cal
Spas chemicals only. Most chemical manufacturers use
different chemical formulas and strengths. Only Cal spas
chemicals are specially formulated to provide chemical
balance at lower dosages. Always read and follow printed
instructions on chemical bottles and packages.
Day One (Monday)
Test spa water using “Bromine Test Strips”.
Based on the test strip readings:
Adjust total alkalinity rst (acceptable range of
80-120 ppm).
Adjust the pH if needed (range is between 7.2
to 7.8).
Add Cal Spas “Bromine Tablets” if needed (do
not add more than 2).
The recommended level of bromine is 3-5 ppm.
Add 2 oz of “Stain and Scale Defense”.
Remove dirty lter from the spa and rinse off. Allow
to dry.
Place your extra clean lter cartridge back into the
spa.
Vacuum debris from the bottom of your spa with the
spa vacuum.
Day Two (Wednesday)
Test spa water using bromine test strips.
Based on the test strip reading, adjust total alkalinity,
then the pH if needed.
Day Three (Friday)
Test spa water using bromine test strips.
Based on the test strip reading:
Adjust total alkalinity, then the pH if needed.
Add one bromine tablet (if needed).
Add 2 oz of Cal Spas “Oxidizer Shock” to spa. Run
spa for 15 minutes with cover off.
Replace cover.
1.
2.
•
•
•
•
3.
4.
5.
6.
1.
2.
1.
2.
•
•
3.
4.