Cabela’s
®
Gun Dog
®
— Owner’s Manual
9
Cabela’s
®
Gun Dog
®
— Owner’s Manual
8
Battery Indicator
When the Battery Indicator shows the
low battery symbol (1/6 capacity),
recharge the Transmitter soon. When
only the battery outline is displayed, the
Transmitter’s battery is too low to send
transmissions to the Collar Receiver.
Transmitter must be recharged to
regain operation.
Battery Cautions
Do not charge batteries every night. To
maximize battery life, use the Transmitter
until the Low Battery symbol (1/6
capacity) displays and use the Collar
Receiver until the LED light blinks red.
• Do not disassemble batteries
• Do not short circuit batteries
• Do not expose to high temperature:
60°C/140°F
• Do not incinerate batteries
• Keep batteries out of reach of children
Batteries must be recycled or disposed of
properly. Batteries should NEVER be
discarded in municipal waste.
Battery is at 2/3 to Full capacity.
Transmitter is fully functional.
Battery is at 1/3 capacity.
Transmitter is still fully functional.
Battery is at 1/6 capacity.
Transmitter will operate the Collar
Receiver, but recharge Transmitter
battery as soon as possible.
Battery is almost dead.
Transmitter is unable to operate
the Collar Receiver. Fully recharge
to use again.
c
ontinued from previous page
T
o use Dual Dog mode:
1. Turn on Collar Receiver 1.
2. Set the desired Dog 1 stim level with
the UP and DOWN arrow keys.
3. Press Dog Select button to
switch to Dog 2.
4. Turn on Collar Receiver 2.
5. Set the desired Dog 2 stim level with
the UP and DOWN arrow keys.
6. Press the Prog/Loc button until the
PROG symbol displays, then release
the button.
7. Press the Dog Select button to switch
between DOG 1 – 2 mode (displays
single dog head symbol and stim
number) and DUAL DOG
mode (displays both dog
head symbols and “2d” in
the display).
8. Repeatedly pressing the Dog Select
button switches between DOG 1 – 2
mode and DUAL DOG mode.
9. To save the chosen setting and exit
programming, press and release the
Prog/Loc button.
Remember, the red stim button is for Dog
Collar Receiver 1, and the gray stim
button is for Dog Collar Receiver 2.
When using Dual Dog mode, the following
buttons are not functional:
• Tone
• Alt Stim
• stim level down
• stim level up
GS-7001 ONLY:
Alternate Stimulation (Alt Stim)
Some trainers depend upon instant
access to a higher stimulation setting for
circumstances where the dog may not
respond to lower levels, such as a high
distraction environment. Your GS-7001
Transmitter features a red, preset Alt Stim
button that you can use to deliver an
alternate (higher) level of stimulation.
Program the Alt Stim Button
To change the stimulation level of the
GS-7001 Alt Stim button:
1.Press the Prog/Loc button and hold
until the PROG symbol is displayed,
then release the button.
2.Press the Alt Stim button.
3.Press or until you get to the
desired stimulation level.
4.When finished, press and release the
Prog/Loc button.
400-1139-1.qxp:two column layout for print 9/25/09 4:03 PM Page 8