Filter
Top Products
1. Mount the plastic adapter on the mount as shown. Please note your telescope model number and refer to the
appropriate diagram. Tighten set screw.
2. Using the fine adjustment cable, rotate shaft until the flat side of shaft is visible through the opening in the side of
the plastic adapter.
3. Attach gear coupler to shaft as shown and tighten set screw.
4. Using the fine adjustment cable, rotate shaft until the flat side of the gear coupler cavity matches the position of the
flat side of the Automated Tracking System shaft. Make certain the notches of the plastic adapter and the notches
on the backside of the Automated Tracking System (ATS) securely interface. (Note: The buttons on the ATS should
be on top as shown.)
5. Tighten the set screw to firmly affix the ATS and the plastic adapter.
Once you have assembled your telescope and aligned the equatorial mount with the North Star (see "Understanding the
Equatorial Mount" section), you can begin enjoying the benefit of the Automated Tracking System. The functions of the
system are outlined below:
AUTOTRACK--By pushing this button, you activate the Automated Tracking System and your telescope begins to move
with the night sky. Push and hold this button to turn the unit off. The default motion is set for the Northern Hemisphere.
FWD/REV (FORWARD/REVERSE)--By pushing this button you automatically reverse the direction of the Automated
Tracking System. This can be used to switch tracking direction for the Southern Hemisphere or to back up the telescope
in its tracking motion.
SPEED--The speed buttons (UP AND DOWN) will increase the speed in the direction of tracking or decrease the speed
in the direction of tracking.
LED INDICATOR--The green LED light on the ATS when lit indicates that the ATS is operating. When fresh batteries are
required, the green LED will change to red.
The ATS requries a 9-volt alkaline battery (user-supplied). To install or replace, simply remove the battery door located
under the Bushnell logo, attach battery to clamps, and replace battery door.
NOTE: PROPER ALIGNMENT OF THE EQUATORIAL MOUNT AND FRESH ALKALINE BATTERIES WILL ENSURE
THE BEST AUTOMATED TRACKING SYSTEM SUCCESS.
13.
AUTOMATED TRACKING SYSTEM INSTALLATION
AUTOMATED TRACKING SYSTEM OPERATION
CHANGING BATTERIES