Filter
Top Products
BUSH HOG
®
UTILITY VEHICLE WORKSHOP MANUAL – SECTION 7: STEERING SYSTEM
7-9
INSTALLATION
CAUTION
When working underneath a raised vehicle, always support the vehicle with jack
stands to prevent the vehicle from falling. A falling vehicle can cause severe
personal injury or death.
RACK AND PINION INSTALLATION
1. Position the rack and pinion assembly against the firewall for
installation.
2. Using the note indicating the number of turns required to unscrew
the tie rod ends; install the tie rod ends the same number of
revolutions (Figure 12).
3. Securely tighten the tie rod end lock nuts.
4. Position the rack and pinion assembly with the tie rod ends
resting in the strut steering arms.
NOTICE: The rack and pinion shaft can only be installed in one
position, one spline on the shaft is wider than the others and
must be aligned with the wider slot in the U-joint.
5. Install the pinion assembly into the lower steering shaft U-joint.
Secure the U-joint and pinion input shaft with a capscrew, lock
washer and hex nut. Tighten nut securely.
6. Install three capscrews and hex nuts securing the rack and
pinion assembly to the fire wall (Figure 13). Tighten securely.
7. Install two capscrews through the right side rack extension
bracket and frame support. Secure the bracket with two hex
nuts. Tighten securely.
8. Install a slotted nut on both tie rod ends. Tighten the nuts to 30
lbs. ft. (41 Nm) then back off to the first through slot.
9. Install and lock a new cotter pin in each slotted nut and tie rod end.
TIE ROD
END
LOCK
NUT
Figure 12
Tie Rod Installation
Figure 13
Rack and Pinion
CAPSCREWS