Filter
Top Products
ASSEMBLY
2647 01/11 Assembly Section 3-6
© 2011 Alamo Group Inc.
ASSEMBLY
6. Move lift and bucket control levers back and forth several times to relieve pressure on the lift and bucket
cylinders. Disconnect quick couplers between loader and tractor. Hang hoses over the side frame for
storage. If equipped with optional auxiliary 1-lever valve, remove support assembly from the guide tube
on midmounting also. Slide valve support assembly into hole provided at rear of right side frame channel.
7. Fasten bolts, washers and nuts onto hinge for storage.
8. Start tractor engine, release tractor brakes and slowly back the tractor away from the loader.
Note: The loader should be stored in a dry place. If loader is being stored for an extended period of time (one
month of more), a coat of heavy grease should be applied to the cylinder shafts to prevent rusting.
Mounting Loader
Mounting is basically reverse of dismounting.
1. Slowly drive tractor up to loader until the hoses will reach loader to the tractor. Engage tractor brakes and
shut off tractor engine.
2. Connect quick couplers between tractor and loader. If equipped with optional 1-lever valve, reinstall valve
support assembly back into the valve support guide tube also.
Note: Make sure couplers are clean.
3. Remove bolts, washers and nuts from hinge.
4. Start tractor engine and release tractor brakes. Slowly drive tractor ahead while activating lift cylinder
control lever to allow the front brackets to engage the side frames through the notches in lower flange.
Continue sliding the loader on the front mounting bracket until the side frame uprights are fully resting on
midmounting assembly. Engage tractor brakes and shut off tractor engine.
Make sure both front mountings engage loader side frame channels through notches
provided.
5. Clamp hinge assembly of upright around tube of midmount assembly. Install bolts, washers and nuts, and
securely tighten.