Filter
Top Products
DURING IMPLEMENT ADJUSTMENT
KEEP BODY, HANDS AND FEET CLEAR
OF SPOONS OR FRAME.
ATTACHMENT (Lift Type)
The implement should be placed on level ground.
Place the tractor rockshaft control in “position con-
trol” (non-floating) for attaching and detaching the
implement. “Draft control” or “position control” can
be used while operating.
Attach the center link to the top of the mast and
adjust so that the frame will be level in the operating
position. Remove parking stand and store in the
upside down position.
DETACHING FROM TRACTOR
Pin parking stand into position and lower the imple-
ment to the ground with rockshaft control in position
control. Remove top link from mast, disconnect hitch
arms from bottom pins and pull tractor away from
implement.
Back the tractor until the ends of the lift arms can be
attached to the lift points on the implement. Secure
the lift arms to the mast. (Figure 1)
6
WARNING
Figure 1 PG-720 Plugger
Top Link
Lift Point
Lower Lift Point
Parking Strand
Mast
Greasable Shaft Sleeve
Spoons
Weight Rack
SPECIFICATIONS
MODEL SIZE TYPE HITCH HUBS SPOONS APPROX. WT.
PG-300 30” Pull 4 32 175 lbs.
PG-480 48” Lift 6 48 290 lbs.
PG-600 60” Lift 8 64 350 lbs.
PG-720 72” Lift 10 80 390 lbs.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
SECTION I
OPERATION