Filter
Top Products
BUSH HOG L.L.C.
MOUNTING INSTRUCTIONS
50051729 CABLE CONTROL VALVE KIT
50051730 CABLE CONTROL VALVE KIT
HYDRAULIC ATTACHMENT
FOR MID MOUNT LOADERS
(See Page 2 for Mounting Instructions)
ATTACHING HANDLE MOUNT, CONTROL HANDLE
AND CABLES TO TRACTOR
1. CAUTION: Before leaving tractor seat, stop engine, lock brake, relieve hydraulic pressure,
and remove key. Do
Not allow bystanders in work area.
2. Locate an area in the front-right side of tractor floor board to mount the support mount.
(NOTE
: If the floor board has a floor matt, role the matt back in the area chosen to
check for pre-drilled mounting holes by the tractor manufacturer). If mounting holes
will have to be drilled, make sure the area on the underside of the floor board has no
cables, tubes, linkages or any other obstructions that would interfere or be damaged by
drilling to mount the support weldment.
Page 1
03/11/06
62-06
Instruction Sheet No. 50051651
R
P.O. Box 1039 Selma, AL 36702-1039 (334) 874-2700
101 Bush Hog Boulevard Telford, TN 37690-2421 (423) 788-7100
WARNING
THE LOADER CAN FALL FROM HYDRAULIC
SYSTEM FAILURE. TO AVOID SERIOUS
INJURY OR DEATH, SECURELY SUPPORT
LOADER BEFORE WORKING UNDERNEATH.
CAUTION
USE A PIECE OF CARDBOARD OR WOOD RATHER
THAN HANDS AND WEAR EYE PROTECTION WHEN
SEARCHING FOR HYDRAULIC LEAKS. ESCAPING
HYDRAULIC OIL UNDER PRESSURE CAN PENETRATE
SKIN. IF OIL IS INJECTED INTO SKIN, IT MUST BE
SURGICALLY REMOVED WITHIN A FEW HOURS BY A
DOCTOR OR GANGRENE MAY RESULT.