Filter
Top Products
ASSEMBLY
1947/2047 01/11 Assembly Section 3-2
© 2011 Alamo Group Inc.
ASSEMBLY
Assembly Instructions
To avoid injury during installation of loader, do not allow bystanders within 10 feet of loader
or attachment.
Always have a heavy attachment, such as a bucket mounted on loader when it is removed
from tractor.
Always use a drift and hammer made of non-sparking material (a shot-filled mallet is
recommended) to install or remove pins. A steel hammer or drift could generate flying metal
fragments and result in injury. Always wear safety glasses when using a hammer to remove
or install pins.
Always have a heavy attachment, such as a bucket mounted on loader when it is removed
from tractor.
It is important not to put excessive weight on parking stands with lift cylinder retraction.
Damage may result.
Never allow anyone to get under the loader or attachment or to reach
through the loader lift arms when raised. Serious injury could result from
crushing or pinching by the loader or attachment.
(SL-06)
Make sure the loader is properly attached to the tractor and the retaining pins securely lock
the loader into position. Improper mounting of the loader onto the tractor can result in the
loader falling causing serious injury.
(SL-23)
Only mount the loader on a tractor that is listed on the mounting instructions. Never mount
on a tricycle steering front axle. Move the tractor front and rear wheels to the widest spacing
and add the recommended rear tractor ballast to prevent tractor tip over. Keep the tractor
tires properly inflated. Maintain at least 25% of the total Tractor and Loader weight including
the maximum load in the bucket or attachment on the rear axle. Always wear your seatbelt
and make sure the ROPS structure is fully deployed to prevent serious injury or death from
the tractor tipping over.
(SL-11)
Make sure all air is purged from the hydraulic system before using the loader. Air in the
system can cause the loader to respond sluggishly or with unexpected movement. The air
can be purged from the cylinder lines by fully cycling the cylinders several times from the
fully closed to fully open position. Sudden or unexpected movement or dropping of the
loader and attachment could result in serious injury.
(SL-32)