Filter
Top Products
Swath Roller
6
ASSEMBLY
1. Center the drum shaft (#2) in the drum (#1) and tighten in place using
the set screws supplied in the hubs at the ends of the drum.
2. Slide the right and left side frames (#7) and (#8) onto the drum shaft
with the side frames turned as shown in drawing.
3. Assemble the cross brace (#3) between the two side frames. Do not
tighten the clamp bolts until after the bearings on the side frames
have the collars locked in place. NOTE: When mounting bearings on a shaft,
always tighten the bearing collar in the direction of shaft rotation using a
center punch or a similar tool.
4. Clamp the hitch (#4) to the center of the cross brace.
ALERT: The 10’ Swath Roller has two additional braces (#31)
clamped to both sides of the hitch.
OPERATION
THEORY OF OPERATION