Filter
Top Products
Drag Harrow
6
DRAG HARROW ASSEMBLY INSTRUCTIONS
1. Assemble the hitch (#1), boom (#2) and braces (#3) using the hardware
supplied.
2. Mount the assembly on the tractor using the three point pins.
3. Space the stakes according to the size of harrow sections used (see drawing
on next page). Mount the stakes using stake caps, ½” x 1 ½” hex bolts, ½”
lock washers and ½” hex nuts. Simultaneously fasten the 10-link drag chain
between the stake and stake cap using the same bolts. A 7/16” long spacer
is fitted in the last link of drag chain. The bolt goes through the spacer and
prevents the chain from being clamped tight.
STAKE SPACING FOR DRAG HARROWS
4. Bolt the ¼” lift chains to the top of the stakes using 3/8” x 1 ½” hex bolts, flat
washer and lock nuts. Use about 21 links on the lift chain to attach the stake
to the harrow section.