Briggs & Stratton MODEL 350000 Lawn Mower User Manual


 
10
This engine is shipped from Briggs & Stratton
without oil. If you start the engine without oil, the
engine will be damaged beyond repair and will
not be covered under warranty.
Troubleshooting
Starter Handle will Not Pull
Place equipment on flat level surface.
Remove all external equipment/engine loads before
starting engine.
Direct coupled equipment components such as, but
not limited to, blades, impellers, pulleys, sprockets,
etc., must be securely attached.
WARNING
When starting engine, pull cord slowly until
resistance is felt, then pull rapidly.
Rapid retraction of starter cord
(kickback) will pull hand and arm
toward engine faster than you can
let go.
Broken bones, fractures, bruises
or sprains could result.
Engine will Not Start
Out of Fuel
Add fuel to tank.
Engine Flooded
Gasoline engine: Set choke (if equipped) to
OPEN/RUN position, and continue to pull starter
handle.
Spark Plug Fouling
Check and ensure the spark plug is clean. Check the
gap with a feeler gauge and reset to .76 mm or .030
in. if necessary.
If the electrode is burned or worn, replace spark plug
with new spark plug.
CAUTION
If engine is tipped to transport equipment, to
remove debris, to drain oil, etc., keep the spark
plug side of engine up.
CAUTION
Engine is Smoking or Running
Rough
Engine may have been tipped during
transport.
Check for fouled spark plug.
Check air cleaner filter for oil saturation. Squeeze
pre-cleaner in clean, absorbant cloth to remove ALL
EXCESS oil. If air cleaner is saturated, replace with
new cartridge.
Ensure fuel cap is in place before
starting engine
Turn engine OFF and let engine cool
at least 2 minutes before removing
fuel cap.
Check fuel lines, tank, cap, and fittings
frequently for cracks or leaks. Replace
if necessary.
Do not crank engine with spark plug
removed.
WARNING