Filter
Top Products
1.19
To prevent accidents stop the engine disconnect the spark plug
lead before attempting to carry out maintenance procedures on
the mower.
1. Finger Guard
2. Carburettor
3. Spark Plug / Lead
4. Exhaust Guard
5. Exhaust
6. Oil filler Cap/ Dipstick
7. Start Grip
8. Fuel Cap
10. Air Cleaner
Loosen the outer cable clamp screw (1) and move the governor control
lever (2) to the left as far as possible. Insert a large, flat blade screw
driver (3) into the slot in the engine control bracket (4) at the angle
shown. Push the governor control lever to the right until it just touch-
es the screw driver blade. Move the throttle control lever to the ‘fast’
position (not the ‘choke’ position) and re-tighten the outer cable clamp
screw. Replace the engine cowl.
Should only be made by an authorised Briggs & Stratton dealer. Under
no circumstances should the engine be adjusted to run at a speed in
excess of that shown on the Declaration of Conformity.
MOWER
3D319R08
7
8
9
2
4
5
6
1
3
1
2
3
4
Engine
Throttle Cable Adjustment
Carburettor Adjustments
MAINTENANCE