Briggs & Stratton BARON XL Lawn Mower User Manual


 
Troubleshooting
While normal care and regular maintenance will extend the life
of your equipment, prolonged or constant use may eventually
require that service be performed to allow it to continue
operating properly.
The troubleshooting guide below lists the most common
problems, their causes, and remedies.
See the information on the following pages for instructions on
how to perform most of these minor adjustments and service
repairs yourself. If you prefer, all of these procedures can be
performed for you by your local authorized dealer.
WARNING
To avoid serious injury, perform maintenance on the
tractor or mower only when the engine is stopped and
the parking brake engaged.
Always remove the ignition key, disconnect the spark
plug wire and fasten it away from the plug before
beginning the maintenance, to prevent accidental
starting of the engine.
Troubleshooting the Tractor
PROBLEM LOOK FOR REMEDY
Engine will not
turnover or start.
Brake pedal not depressed. Fully depress brake pedal.
PTO (electric clutch) switch is in ON position. Place in OFF position.
Cruise control engaged. Move knob to NEUTRAL/OFF position.
Out of fuel.
If engine is hot, allow it to cool, then refill
the fuel tank.
Engine flooded. Disengage the choke.
Fuse is blown. See authorized dealer.
Battery terminals require cleaning. See Cleaning the Battery and Cables.
Battery discharged or dead. Recharge or replace battery.
Wiring loose or broken.
Visually check wiring. If wires are frayed or
broken, see authorized dealer.
Solenoid or starter motor faulty. See authorized dealer.
Safety interlock switch faulty. See authorized dealer.
Water in fuel. See authorized dealer.
Gas is old or stale. See authorized dealer.
Engine starts hard or
runs poorly.
Fuel mixture too rich. Clean air filter.
Engine has other problem. See authorized dealer.
Engine knocks.
Low oil level. See engine manual.
Using wrong grade oil. See engine manual.
Excessive oil
consumption.
Engine running too hot. See authorized dealer.
Using wrong grade oil. See engine manual.
Too much oil in crankcase. Drain excess oil.
Troubleshooting &
Adjustments
22
Not for
Reproduction