Filter
Top Products
S200X 25HP & 27HP - 61” Mower Deck
7/2007 5
TP 300-7333-02-M2-SP
Roll Bar Installation
Install the Roll Bar
1. Unpack the roll bar and hardware from the box.
2. Place the roll bar in to the roll bar pockets (A, Figure
6) on the frame. Refer to Figure 7 for the correct roll
bar orientation.
3. Install the allen head bolt with a flat washer through
the bottom hole of the roll bar pocket and roll bar
from the rear of the machine. Secure with a flat
washer and the center lock nut. Repeat for the other
side.
4. Install the hex head bolt with washer through the top
hole of the roll bar pocket and roll bar from the rear of
the machine. Secure with a flat washer and the
center lock nut. Repeat for the other side.
5. Tighten installation hardware to 80 ft/lbs (108 Nm) of
torque.
Figure 6. Roll Bar Pocket (Left Side Shown)
A. Roll Bar Pocket
A
Figure 7. Roll Bar Orientation