Filter
Top Products
MODEL 37610701 - 04
PeCo
Diagnostic Procedures
Trouble shooting procedures are provided in the chart below. To use these procedures,
first locate the problem description that best describes the trouble that you have encoun-
tered. Check the possible causes one at a time in the list. Correct any problems that are
found and operate the vacuum collector again to verify that you have eliminated the problem.
DO NOT attempt any major repairs without first contacting your dealer.
OUTDOOR POWER EQUIPMENT
Arden, North Carolina 28704
Model Number
Serial Number
The Serial Number Plate is located
on the aluminum box near the
dump handle.
TROUBLE SHOOTING
11
PROBLEM CAUSE SOLUTION
Leaves and Grass 1. Engine speed too slow A. Run at full throttle.
not being picked 2. Ground speed too fast. B. Use lower gear
up completely. 3. Hose plugged. C. Check and tighten all hoses.
D. Unplug hose.
Hoses plug easily. 1. Grass or leaves too wet. A. Wait for drier conditions.
2. Grass too high. B. Reduce tractor ground speed/raise deck.
3. Container full. C. Empty container
4. Grass buildup in boot or D. Clean thoroughly.
under mower deck.
Vacuum Collector 1. Buildup on blower blades. A. Remove cone and clean blades.
blower vibrates 2. Bent or chipped blade. B. Contact your dealer or PeCo.
excessively.
Unit fails to fill box. 1. Engine speed too slow. A. Run at full throttle.
2. Buildup on inlet or screen B. Clean thoroughly.
3. Grass is too wet or long. C. Wait for dryer conditions.