Filter
Top Products
11
2. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on the
nozzle extension.
3. Select desired spray tip:
• For gentle rinse, select white 40° spray tip.
• To scour surface, select yellow 15° or red 0° spray
tip.
• To apply chemical, select black spray tip.
4. Pull back on collar, insert new spray tip and release
collar.Tug on spray tip to make sure it is securely in
place.
5. For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too close, you may damage cleaning surface. DO
NOT get closer than 6 inches when cleaning tires.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.Always start the turbo nozzle at a
distance, gradually getting closer to the surface until you
get the cleaning force you want.
1. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on the
nozzle extension.
2. Pull back on collar, insert turbo nozzle and release
collar (Figure 16).Tug on turbo nozzle to make sure it
is securely in place.
3. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with the turbo
nozzle.
How to Use the Utility Brush
The utility brush allows you to scrub surfaces with water
filtering through the bristles.
To attach the utility brush to the spray gun:
1. Tighten the adapter to the brush base.
2. Remove the nozzle extension from the spray gun, if
attached.
3. Attach the brush with the adapter to the spray gun.
Tighten by hand (Figure 17).
NOTE: You must use the adapter to attach the brush to
the spray gun.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent follow these steps:
1. Review spray tip use.
2. Prepare detergent solution as required by manufacturer.
3. Hang detergent solution on “J” hook attached to
accessory tray, as shown in Figure 18.
Section 4: Operation
CAUTION
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
You must attach all hoses before you start the engine.
• Always make sure the surface you will clean will not be
damaged by the high pressure spray by testing in a hidden area.
The turbo nozzle produces an extremely high pressure
spray which is capable of removing paint and cutting
holes through surfaces if held too close.
CAUTION
Figure 17 - Attaching Utility Brush to Spray Gun
Figure 18 — Insert Filter into Container
Figure 16 - Attaching Turbo Nozzle to Nozzle Extension