Filter
Top Products
Speed Clean™ 2300 PSI Pressure Washer
6
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to engine owners manual to add recommended oil
to engine.
NOTE: Check Oil Often During Engine Break–in.
Add Fuel
WARNING! NEVER fill fuel tank indoors. NEVER
fill fuel tank when engine is running or hot.Allow unit
to cool for two minutes before refueling. DO NOT
light a cigarette or smoke when filling the fuel tank.
WARNING! DO NOT overfill the fuel tank.
Always allow room for fuel expansion.
• Place pressure washer on a level surface.
• Refer to engine owners manual to add recommended
fuel to engine.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1. Uncoil the high pressure hose and attach one end of
the hose to the base of the spray gun (Figure 5).
Tighten by hand.
2. Attach the other end of the high pressure hose to the
high pressure outlet on the pump (Figure 6).Tighten by
hand.
3. Before you connect your garden hose to the water
inlet, inspect the inlet screen (Figure 7). Clean the
screen if it contains debris or have it replaced if
damaged. Refer to the section “O-Ring Maintenance”
on page 13 if the inlet screen is damaged. DO NOT
RUN THE PRESSURE WASHER IF THE INLET
SCREEN IS DAMAGED.
Connect high
pressure hose
here
Figure 5 — Connect High Pressure Hose to Spray Gun
Figure 6 — Connect High Pressure Hose to Pump