Document: - page 13 (Black)
Screen angle and frequency: 45.0000, 150.0000
13
MAINTENANCE
ENGINE AND ENGINE PARTS
We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the engine
and engine parts. Use only genuine Briggs & Stratton parts.
WARNING
If you perform any maintenance on the engine, first disconnect the spark plug wire
from the spark plug, and disconnect the battery at the negative terminal (electric
starter engines only) to prevent unintentional sparking. Unintentional sparking can
result in fire or electric shock. Unintentional start-up can result in entanglement,
traumatic amputation or laceration. Use only correct tools.
WARNING
• Do not strike the flywheel with a hammer or hard object because the flywheel may
later shatter during operation.
• Do not tamper with governor spring, links or other parts to increase engine speed.
MUFFLER
Replacement parts for the muffler
must be the same and installed in the
same position as the original parts,
otherwise fire can occur.
If muffler is equipped with spark arrester screen, remove scree
n
for inspection. Replace screen if damaged or plugged.
WARNING
SPARK PLUG
Use only Briggs & Stratton Spark Tester (part number
19368) to check for spark.
Note: In some areas, local law requires using resistor spark
plug to suppress ignition signals. If this engine was
originally equipped with resistor spark plug, use same type
for replacement.
.030” (0.76 mm)
WIRE GAGE
RESISTOR P/N 491055
FUEL SYSTEM
Replacement parts for fuel system
(cap, hoses, tanks, filters, etc.)
must be the same as original parts,
otherwise fire can occur.
WARNING
REPLACE FUEL FILTER (if equipped)
Drain fuel tank or close fuel shut-off valve before replacing
fuel filter. Otherwise, fuel can leak out, creating a
fire/explosion hazard.
FUEL FILTER
P/N 499638
FUEL HOSE
CLAMPS