Filter
Top Products
Attach Hose Reel
You will need the following tools to assemble the hose reel:
• 8 mm wrench
• Phillips screwdriver
1. Place hose reel onto left side of handle (A) (viewing
from handle side of unit) just above carriage bolt. Make
sure pin (B) in hose reel clamp inserts in hole (C) on
handle.
NOTE: Make sure hose reel is attached to the handle facing
the engine.
2. Close hose reel clamp (D) and insert “T” bolt (E).
Tighten by hand.
3. Remove shipping cap from fitting on hose reel and
attach one end of shorter high pressure hose to hose
reel fitting. Tighten by hand.
4. Attach other end of shorter high pressure hose to high
pressure outlet on pump. Tighten by hand.
5. Uncoil high pressure hose and slide metal reinforced
end through hole of hose reel.
6. Attach high pressure hose to fitting on hose reel.
Tighten by hand.
7. Slide hose clamp (F) onto high pressure hose. Using an
8 mm wrench and a phillips screwdriver, attach hose
clamp to hose reel with screw (G) and lock nut (H).
8. Pull ring on pin and rotate to vertical position to lock
pin open.
9. Pull hose reel handle outward and coil high pressure
hose onto hose reel.
10. Line up pin with hole in hose reel and pull ring on pin.
Rotate to horizontal position and let ring slide into
groove to lock hose reel in place.
9
B
A
C
D
E
G
H
F