Filter
Top Products
2600 PSI Pressure Washer
9
How to Use the Adjustable Nozzle
You should now know how to START and STOP your
pressure washer.The information in this section will tell
you how to adjust the spray pattern and to apply detergent
or other cleaning chemicals.
1. Slide nozzle forward when you wish to adjust spray to
low pressure mode (Figure 9). Slide nozzle backward
to achieve high pressure.
2. Point nozzle down towards a firm surface and press
trigger to test pattern (Figure 10).
3. Twisting nozzle adjusts spray pattern from a narrow
pattern to a fan pattern (Figure 11).
4. For most effective cleaning, keep spray nozzle from
8 to 24 inches away from cleaning surface.
5. If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
6. DO NOT get closer than 6 inches when cleaning tires.
Using the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.The high pressure spray is most
effective when the tip of the nozzle extension is held
between 8 to 24 inches from the surface being cleaned.
To attach the turbo nozzle to the spray gun:
1. Engage safety latch to spray gun trigger.
2. Remove the nozzle extension from the spray gun, if
attached.
3. Attach the turbo nozzle extension to spray gun
(Figure 12).Tighten by hand.
Slide nozzle backward
for High Pressure
Mode
Slide nozzle forward for low
pressure mode and
detergent application
Figure 9 — Adjusting Nozzle for Pressure
Figure 10 — Testing the Spray Pattern
Figure 11 — Adjusting the Nozzle for Spray Pattern
Rotate nozzle
counterclockwise for fan
spray pattern
Rotate nozzle clockwise
for narrow spray pattern
Figure 12 — Connect Turbo Nozzle Extension to Spray Gun
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
CAUTION
CAUTION
• Always make sure the surface you will clean will not be
damaged by the high pressure spray by testing in a hidden area.
The turbo nozzle produces an extremely high pressure
spray which is capable of removing paint and cutting
holes through surfaces if held too close.