Filter
Top Products
6
Cleaning and maintenance
After every shave, remove the foil
frame
7 (d) and tap out lightly. Brush
out the cutter block
6 with the clean-
ing brush
9 (e). Do not clean the
shaving foil with the cleaning brush
9
to avoid damaging it. Approximately
every four weeks clean the space
between the longhair trimmer
5 and
the shaver with the cleaning brush
9.
Clean the cutter block
6 with Braun
cleaning spray to maintain your shav-
er’s top shaving performance and to
keep it hygienic. After every cleaning
replace the foil protection cap
8 on
the foil frame
7.
Changing the shaving parts
The shavin
g foil frame 7 should be
held at the two grooved surfaces and
pulled off (d).
The cutter block
6 can be removed
(e.g. for cleaning) by turning it at
right angles to the shaver and lifting
it off (f). To replace the cutter block,
snap it onto the holding studs (g).
Replace the new foil frame in the
ri
ght direction (d) until it locks in place.
Important
Buy only original Braun spare parts,
especially when replacing the mains
lead or the shaving foil frame
7.
When buying a new shaving foil
frame look for the brand and
the correct identification number
«596» (h).
When looking to purchase a new
Braun foil frame, ensure that you
buy the right colour: a grey or black
coloured frame.
Only this way you can be assured of
a safe, close and efficient shave.
Parts for car or boat
When recharging your shaver in a car
or boat use only the special Braun
charging cord (No. 5-001-687) that is
stated on the packaging for this
purpose (available at your dealer or
from a Braun Service Centre). Avoid
direct sunlight on the shaver (see
temperature range).
Subject to change without notice.
This product conforms to the
EMC-Requirements as laid
down by the Council Directive
89/336/EEC.
5597102_1508_S4-62.fm Seite 6 Dienstag, 25. Juni 2002 10:19 10