Filter
Top Products
7
Q
UICK-START DEMONSTRATION
I. Supplies Needed
• A Nail • A Quarter
• A Pull-Tab from a beverage can • A Zinc Penny (dated after 1982)
• A Nickel
II. Position the Detector
a. Place the detector on a
table, with the searchcoil
hanging over the edge.
(or better, have a friend
hold the detector, with
the coil off the ground)
b. Keep the searchcoil away
from walls, floors, and
metal objects.
c. Remove watches, rings and other jewelry or metal objects from
hands and wrists.
d. Turn off appliances or lights that cause electromagnetic interference.
e. Pivot the searchcoil back
toward the detector body.
III. Power Up
Turn Ground Balance knob to
pre-set position.
Press the POWER touch pad.
IV. Wave each Object over the
Searchcoil
a.Notice a different tone for each object.
Bass Tone: Nail
Low Tone: Pull-Tab
Medium Tone: Zinc Penny
High Tone: Quarter
b.Motion is required. Objects
must be in motion over the
searchcoil to be detected.
V. Press the DISC A-M touch pad
The detector will beep twice
and 3 “R”’s will appear
under the iron indicators.
Quick-Start Demo continued
on next page