Filter
Top Products
6
3
Setting Up
Your Snow
Thrower
NOTE: References to right
or left side of the snow
thrower are determined
from behind the unit in the
operating position (standing
directly behind the snow
thrower, facing the handle
panel).
1. Observe the lower rear area of the snow thrower to
be sure both cables are aligned with roller guides
before pivoting the handle upward.
2. Secure the handle by tightening the plastic wing
knob located on both the left and right sides of the
handle. Remove and discard any rubber bands, if
present. They are for packaging purposes only.
3. Position the chute assembly over the base.
4. Close the flange keepers to secure the chute
assembly to the chute base. The flange keepers will
click into place when properly secure.
NOTE: If the flange keepers will not easily click into
place, use the palm of your hand to apply swift, firm
pressure to the back of each.
NOTE: Two replacement
auger shear pins are
included with this manual
(or stowed in the plastic
handle panel). Refer to
Augers on page 16 for more
information regarding shear
pin replacement.
NOTE: Snow throwers vary
by model with regard to
features and components.
Your snow thrower may
NOT resemble, in detail,
snow throwers illustrated
in figures throughout this
manual.
2
3
1
4