Filter
Top Products
8
• With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the starter rope out of the
engine. Release the blade control handle. Slip the
starter rope into the rope guide. Tighten the wing
nut.
Installing Front Wheels
• Place the front of the mower deck on raised blocks.
• Slide wheel onto pivot arm assembly and secure
with lock nut. See Figure 5.
• Assemble the other side in the same manner.
• If your mower is equipped with hub caps, place hub
caps in position against the inner hub of wheel.
Press firmly around the center portion of the hub
cap in a circular motion. The hub caps are flexible
and they will snap over the wheel hubs.
Figure 5
Installing Rear Wheels
• Place the rear of the mower deck on raised blocks.
• Place spring washer (cupped side toward handle
bracket assembly) on the axle that extends from the
pivot arm assembly. See Figure 6.
• Slide wheel, with hollow side in, onto axle and
secure with lock nut.
• Assemble the other side in the same manner.
Figure 6
Lock Nut
Pivot Arm
Assembly
Spring
Washer
Lock
Nut