Filter
Top Products
Contact 1.800.762.1142 for assistance.
Do not return to place of purchase.
Owner’s manual: model GWU511A outdoor patio heater
7
Contact 1.800.762.1142 for assistance.
Do not return to place of purchase.
Owner’s manual: model GWU511A outdoor patio heater
8
Step 2: Attach wheel assembly
A. Attach wheel assembly to base using 3 sets of small bolt (D), medium lockwasher (M),
medium nut (I).
B. Tighten bolts once all bolts are in place.
Assembly Instructions
General Components & Features
Familiarize yourself with all components before proceeding. Refer to page 5 for hardware and components, and page 21 for specifications.
Do NOT attempt assembly unless all components are available. If you believe a component is missing or damaged, contact 1.800.762.1142 for
assistance.
Note: All hardware is mounted on a cardboard pack and numbered to match their assembly step.
Additional Requirements
The following items are not included, but are necessary for the proper assembly of your heater. Do NOT attempt to assemble without proper tools.
(1) Leak Detection Solution (Instructions on how to make solution are included in “Checking for Leaks” section)
(1) Precision Filled LP Gas Grill Tank with Acme Type 1 external threaded valve connection (4-5 gallon size)
Note: You must follow all steps to properly assemble heater.
Typical assembly: approximately 1 (one) hour.
Image shown
from bottom
Step 1: Unpacking heater
Note: When unpacking your heater from the carton, you will find that the engine assembly
and the base have been bolted together for shipping purposes.
Remove the three nuts at the top of the base and separate the engine from the base.
Note: Retain these nuts as you will use them later.