Filter
Top Products
Assembly Section 3-3
ASSEMBLY
BREEZE 08-01
© 2004 Alamo Group Inc.
ASSEMBLY
CASTER WHEEL ATTACHMENTS
Axle arm (1) comes attached to deck weldment. Install caster fork assemblies by installing spacers (2) onto fork
shaft (4) and inserting into tube with bushings on each end of axle arm (1). Place spacers (5) on top of tube and
retain using pin (3). See Figure 2.
DRIVELINE ATTACHMENT - To Gearbox
1. Insert yoke onto splined shaft. Twist red collar on end yoke.
2. Slide yoke (with collar twisted) onto gearbox shaft.
3. Move yoke back and forth until collar clicks and locks the yoke in place.
2
1
3
4
5
FIGURE 2