Filter
Top Products
Joining Center Extension to Saw Head Module and
Handle Module
Adding the extension (B) to the handle module (A) and saw head
module (C) creates a Pole Saw that is approximately 9 foot in length
as shown in figure 13.
To attach the middle module to the handle module and saw head
module:
1. Align the groove on the outside of the
coupling end of the handle module (A)
with the tongue on the inside of the
coupling end of the center extension (B).
See figure 14. Push the two sections
completely together.
2. Slide the threaded sleeve (6) (figure
15) on the center extension down as far
as possible and rotate the sleeve
clockwise until it stops and completely
covers the orange threads as shown in
figure 16.
3. Repeat steps 1 and 2 above to attach
the saw head module to the center
extension.
WARNING: Always check to make
sure that the sleeve is completely
threaded on and that the orange threads are no longer visible.
Not threading the sleeve completely on could result in the modules
becoming disconnected creating a hazardous condition.
Periodically check the connections to insure that no orange threads
are visible.
Groove
14
15
16
13
10
Assembly
Joining Saw Head Module to 18V Handle Module
WARNING: Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
and that the protective scabbard is in place on the chain before
performing the following operations. Failure to do this could result
in serious personal injury.
The three modules which make up the 18V Pole Saw are keyed to
insure correct assembly. If a module does not smoothly attach to
another do not force fit.
Combining the handle module (A) to the saw head module (C)
creates a pole saw that is approximately 6 foot in length as shown in
figure 9.
To attach the handle module to the saw head module:
1. Align the groove on the outside of the coupling end of the handle
module (A) with the tongue on the
inside of the coupling end of the saw
head module (C). See figure 10. Push
the two sections completely together.
2. Slide the threaded sleeve (6) figure 11
on the saw head module down as far as
possible and rotate the sleeve clockwise
until it stops and completely covers the
orange threads as shown in figure 12.
WARNING: Always check to make
sure that the sleeve is completely
threaded on and that the orange
threads are no longer visible. Not
threading the sleeve completely on
could result in the modules becoming
disconnected creating a hazardous
condition. Periodically check the
connections to insure that no orange
threads are visible.
Groove
10
11
12
9