Filter
Top Products
4
IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CHARGERS
Thismanualcontains importantsafetyinstructionsfor batterychargers.
• Before using charger, read all instructions and cautionary markings
on charger, battery pack, and product using battery pack.
WARNING: Shock hazard. Do not allow any liquid
to get inside charger.
WARNING: Burn hazard. To reduce the risk of
injury, charge only designated Black & Decker batteries. Other types
of batteries may burst causing personal injury and damage.
CAUTION: Under certain conditions, with the
charger plugged in to the power supply, the charger can be shorted
by foreign material. Foreign materials of a conductive nature such
as, but not limited to, steel wool, aluminum foil, or any buildup of
metallic particles should be kept away from charger cavities. Always
unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
WARNING:
• The charger supplied with this product is intended to be
plugged in such that it is correctly orientated in a vertical or
floor mount position.
• DO NOT attempt to charge the battery pack with any chargers
other than the ones in this manual. The charger and battery
pack are specifically designed to work together.
• These chargers are not intended for any uses other than
charging designated Black & Decker rechargeable batteries.
Anyotheruses may resultinriskoffire, electricshock orelectrocution.
• An extension cord must have adequate wire size (AWG or
American Wire Gauge) for safety. The smaller the gauge
number of the wire, the greater the capacity of the cable, that is 16
gauge has more capacity than 18 gauge. When using more than
one extension to make up the total length, be sure each individual
extension contains at least the minimum wire size.
WARNING: To reduce the risk of electrical shock;
do not expose to rain, do not use on wet surfaces. Store indoors.
SAVE THESE INSTRUCTIONS.
The label on your tool may include the following symbols.
V................volts A ....................amperes
Hz..............hertz W ..................watts
min............minutes ..................alternatingcurrent
..........direct current
n
o ..................no load speed
..............
Class II Construction
....................earthing terminal
............safety alert symbol .../min ............strokes
per minute
COMPONENTS
1
2
3
4
5
1. LSW20 Cordless Sweeper
2. On / Off Switch
3. Battery pack
4. Inner tube
5. Outer tube