Black & Decker LST300 Trimmer User Manual


  Open as PDF
of 36
 
11
TROUBLESHOOTING
TRIMMER RUNS SLOWLY
•RemoveBatteryfromtool.
•Check that the spool housing can rotate freely. Carefully clean it if necessary.
•Checkthatthecuttinglinedoesnotprotrudemorethanapproximately 5-3/8 inches (136mm)
from the spool. If it does, cut it off so that it just reaches the line trimming blade.
AUTOMATIC LINE FEED DOES NOT WORK
•RemoveBatteryfromtool.
•Remove the spool cap.
•Pullthecuttinglineuntilitprotrudesapproximately 5-3/8 inches (136mm) from the spool. If
insufficient cutting line is left on the spool, install a new spool of cutting line.
•Ensurethatthelineisnotcrisscrossedonthespoolasdetailedinfigure R. If it is, unwind
the cutting line, then wind it back on the spool neatly so that the lines do not cross.
•Ensure the beginning of the cutting line is pulled tight against the spool as shown in figure Q.
•Alignthetabsonthespoolcapwiththecutoutsinthehousing.
•Push the spool cap onto the housing until it snaps securely into place.
•Ifthecuttinglineprotrudesbeyondthetrimmingblade,cutitoffsothatitjustreachestheblade.
If the automatic line feed still does not work or the spool is jammed, try the following suggestions:
•Carefullycleanthespoolandhousing.
•Removethespoolandcheckiftheleverinthespoolhousingcanmovefreely.
•Removethespoolandunwindthecuttingline,thenwinditonneatlyagain.Replacethe
spool into the housing.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient
and reliable service. Whether you need technical advice, repair, or genuine factory replacement parts,
contact the Black & Decker location nearest you. To find your local service location, call:
1-800-544-6986 or visit www.blackanddecker.com
FULL TWO-YEAR HOME USE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material
or workmanship. The defective product will be replaced or repaired at no charge in either of
two ways. The first, which will result in exchanges only, is to return the product to the retailer
from whom it was purchased (provided that the store is a participating retailer). Returns
should be made within the time period of the retailer’s policy for exchanges (usually 30 to
90 days after the sale). Proof of purchase may be required. Please check with the retailer
for their specific return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or
authorized Service Center for repair or replacement at our option. Proof of purchase may be
required. This warranty does not apply to accessories. This warranty gives you specific legal
rights and you may have other rights which vary from state to state or province to province.
Should you have any questions, contact the manager of your nearest Black & Decker Service
Center. This product is not intended for commercial use.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are
missing, call 1-800-544-6986 for a free replacement.
LATIN AMERICA: This warranty does not apply to products sold in Latin America. For
products sold in Latin America, check country specific warranty information contained in the
packaging, call the local company or see the website for warranty information.
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
 previous next