Filter
Top Products
15
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Line wonʼt feed. • Line tangled in spool. • Unwrap 24 inches (610mm) of line and
rewind.
• Line fails to cut off. • Line cutter in guard is damaged or missing. • Return to service center for repair.
• Line extends past guard. • Rewind or trim line to line cutter.
• Unit will not start. • Battery not installed properly. • Check battery installation.
• Battery not charged. • Check battery charging requirements.
• Battery wonʼt charge. • Battery not inserted into charger. • Insert battery into charger until LED
appears.
• Charger not plugged in. • Plug charger into a working outlet. Refer to
“Important Charging Notes” for more details.
• Check current at receptacle by plugging in a
lamp or other appliance.
• Check to see if receptacle is connected to a
light switch which turns power off when you turn
out the lights.
• Surrounding air temperature too hot or too cold. • Move charger and tool to a surrounding air
temperature of above 40 degree F(4.5°C) or
below 105 degree F (+40.5°C).
For assistance, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK &
DECKER help line at 1-800-544-6986.
See ‘Tools-Electric’
– Yellow Pages –
for Service & Sales
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.