Filter
Top Products
9
Pivoting the Trimmer Head
The trimmer head pivots 180 degrees and can be locked into 5
different positions within that range. To avoid being pinched, wear
gloves and hold unit as shown below.
Before connecting the battery to the unit, be sure the trimmer head is
locked into position.
To pivot the trimmer head:
1. Press in on the locking latch (7) and raise the trimmer head as
shown in figure 11.
2. Lock the trimmer head into any
of the 5 positions. Check to make
sure that trimmer head is locked
into position by trying to move the
motor housing. If it is not locked,
rotate it to the closest lock position.
Operating Positions
can be used to trim and shape hard
to reach areas of hedges and bushes
such as those shown in fig. 12 and 13.
11
12
13
DISASSEMBLY
Detaching Trimmer Head Module
WARNING: Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
and that the protective blade sheath is in place on the blade
before performing the following operations. Failure to do this
could result in serious personal injury.
on the ground and grasp
the center of the trimmer
head module with one
hand figure 7. Use your
other hand to loosen the
threaded sleeve figure
8 and then pull the two
halves apart.
OPERATING THE POLE TRIMMER
WARNING: Read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury.
Connecting the Battery
Place the battery in the tool as shown in figure 9 and be certain that
it is inserted fully into the tool cavity until it “clicks” into place. To
remove the battery from the tool, press down on the release button
on the back of the battery (figure 10) and slide out.
7
8
10
9