Filter
Top Products
8
Vibration
The declared vibration emission values stated in the
technical data and the declaration of conformity have been
measured in accordance with a standard test method
provided by EN 60745 and may be used for comparing one
tool with another. The declared vibration emission value may
also be used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an
estimation of vibration exposure should consider, the
actual conditions of use and the way the tool is used,
including taking account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle in addition to the trigger time.
Warning symbols
The following warning symbols are found on your tool:
Additional safety instructions for batteries and chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not expose the battery to heat.
Do not store in locations where the temperature may
exceed 40°C.
Charge only at ambient temperatures between 10°C
and 40°C.
Charge only using the charger provided with the tool.
When disposing of batteries, follow the instructions
given in the section “Protecting the environment”.
Do not damage/deform the battery pack either by
puncture or impact, as this may create a risk of injury
injury or fire.
Do not charge damaged batteries.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Use your Black & Decker charger only to charge the
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
Labels on the charger
The following symbols are found on your charger:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Do not use your saw in wet conditions or
expose it to rain.
Always wear ear protection.
Always wear eye protection.
Always wear non-slip safety footwear.
Beware of falling objects.
Keep bystanders away.
Do not use on ladders.
To ensure continued safe operation, check the
chain tension as described in this manual after
every 10 minutes of use, and adjust back to a
clearance of 3 mm as required.
Oil the chain after every 10 minutes of use.
Warning! Do not touch chain at the chip
ejection point.
Direction of rotation of the chain.
To ensure continued safe operation, the chain
and guide bar must only be replaced with
original Black & Decker parts. Replacement
chain part number A6158 replacement guide
bar part number 90517720.
Your charging base is double insulated; therefore
no earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.