Filter
Top Products
5
• Before you start chain saw, make sure saw chain is not
contacting any object.
• Do not operate a chain saw with one hand! Serious injury to
the operator, helpers, or bystanders may result from one
handed operation. A chain saw is intended for two-handed use only.
• Keep the handles dry, clean, and free of oil or grease.
• Do not allow dirt, debris, or sawdust to build up on the motor
or outside air vents.
• Stop the chain saw before setting it down.
• Do not cut vines and/or small under brush.
• Use extreme caution when cutting small size brush and
saplings because slender material may catch the saw chain and be
whipped toward you or pull you off balance.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other
injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
SAVE THESE INSTRUCTIONS
SYMBOLS
The label on your tool may include the following symbols.
V................volts A ....................amperes
Hz..............hertz W ..................watts
min ............minutes ..................alternating current
..........direct current
n
o ..................no load speed
..............
Class II Construction
....................earthing terminal
............safety alert symbol .../min ............revolutions per
minute
Features
Before using your Chain Saw familiarize yourself with all operating
and safety features.
3
2
1
5
6
1. Trigger Switch
2. Lock Off Button
3. Oil Reservoir
4. Oil Reservoir Cap
5. Front Hand Guard
6. Battery
7. Ribbed Bumper
8. Guide Bar
4
7
9
8
9. Saw Chain
10. Sprocket Cover
11. Allen Head Screws
12. Guide Bar Scabbard
13. Wrench
14. Charger
15. Rear Handle
16. Front Handle
10
11
12
13
14
15
16
90560838 ccs818 chain saw.qxd: chainsaw booklet new 2/12/10 10:07 AM Page 5