Filter
Top Products
ACCESSORIES
WARNING: DO NOT use this product with any type of
accessory or attachment. Such usage might be hazardous.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority
to operate the equipment. This Class B digital apparatus complies
with Canadian ICES-003.
8
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unit will • Fan cover or vac tube • Install fan cover for
not start. not installed properly blower mode or vac
tube for vac mode.
• Cord not plugged in. • Plug tool into a
working outlet.
• Circuit fuse is blown. • Replace circuit fuse.
(If the product
repeatedly causes
the circuit fuse to blow,
discontinue use
immediately and
have it serviced at a
Black & Decker
service center or
authorized servicer.
• Circuit breaker is tripped. •
Replace circuit breaker.
(If the product
repeatedly causes
the circuit breaker to
trip,
discontinue use
immediately and
have it serviced at a
Black & Decker
service center or
authorized servicer.
• Cord or switch • Have cord or switch
is damaged. replaced at a
Black & Decker
service center or
authorized servicer.
• Unit jammed • Debris blocking fan. •
Remove vac tube and
inspect inlet/outlet for
clogs. Refer to
“Cleaning and Storage
Section -
Maintenance”