Filter
Top Products
Part No. 890049 Form No. F100202A
Page 4 of 8
PUT OIL IN ENGINE
BEFORE STARTING
Read all safety and operating instructions
before assembling or starting this unit.
ASSEMBLY
10
Your Billy Goat is shipped from the factory in one carton, completely assembled except for the upper
handle and accessories. Included with machine are caster kit (890447), felt filter bag (1 each), lawn
liner (3 each), and litter liner (3 each).
6. CONNECT spark plug wire.
7. VERIFY fuel valve on.
SEE ENGINE MANUFACTURER'S
MANUAL (some engine manufac-
tures' have different oil checking
procedures)
1. REMOVE items 8 locknut & 74
screws from lower handle (item
27). Attach and securely tighten
upper handle item 6 to lower
handle as shown.
3. UNFOLD the debris bag
(item 1) position bottom of bag
rod below the bag plate and
pull up and rotate the top of the
bag rod up and secure with the
latch.
4. ATTACH bag hanger strap to bag
supports (item 11), preassembled to
upper handle.
4a. Bag hanger straps are designed
for adjustment when more clearance
is required between bag and ground.
Typically the bottom loop of the strap
is used when operating on turf.
2. REMOVE deflector (item 83)
from box. Discard packing
material. Remove carriage
bolts (item 31) and nut (item 4)
from deflector. Install to bag
plate (item 13) as shown
reusing parts removed (nut
should be on side shown).
Failure to attach
deflector may result in
premature wear to bag.
1.
2.
3.
5.
6.
7.
4.