Filter
Top Products
Part No 790294 Form No F061907B
10
QL2300 Owner’s Manual
MOUNTING: Main unit
GENERAL: Unit must be securely mounted to a trailer, truck bed,
or other similar surface before use. Do not use this unit in a
freestanding position. Unit is not stable until it has been secured in
place.
Secure unit by bolting through the base of the unit and through the
mounting surface using 3/8" dia. bolts, with washers and locking
nuts (see fig. 1)
MOUNTING: Unit can be mounted in various positions. Figure 2
illustrates the mounting options available when using the optional
trailer (Billy Goat Part no. 790112) available from your Billy Goat
dealer. The unit can be mounted to allow vacuuming from either
side as well as from the rear.
MOUNTING: Exhaust elbow
1) Remove the loose hardware from the clamp assembly so that
there are 4 separate pieces (remaining clamp assembly, two half
plates, and a plate split).
2) Slide the assembled plates over the housing flange. The
flange should rest between the bottom plate and the plate split.
3) Slide the elbow over the plate spacer and center it in the clamp.
The elbow flange should now be resting on the housing flange
between the plate split and the top plate.
4) Insert the other plate split beneath the plate spacer so the holes
align and the plate overlaps the flange on the elbow.
5) Secure the assembly with a plate half on top of the elbow
flange and a plate half on bottom of the housing flange using 3, 1"
carriage bolts and 3 lock nuts (removed hardware in step 1).
6) Tighten down the clamp with 2, 1 3/4" carriage bolts, 2 knobs,
and 2 lock nuts (removed hardware in step 1).
Housing
Elbow
Fig. 1
Fig. 2
Step 1&2
Step 3
Step 4
Fig. 5&6
Typical on
both
sides