Billy Goat QB1601,QB1601SP Blower User Manual


 
Part No. 430149 Form No. F121903A
C E 9
5
Page 16 of 16
Solution
Problem
TROUBLESHOOTING
Before Requesting Service Review These Suggestions
20
Possible Cause
Purchased
from
Purchase
Date
Engine Service and Warranty
Contact your nearest engine manufacturer's
authorized servicing dealer.
22.1
21
Serial Plate
Record your machine model, serial number
and date-of-purchase and where purchased
22
Engine PowerUnit (weight)
@
BILLY GOAT INDUSTRIES INC.
P.O. BOX 308, 1803 S JEFFERSON LEE'S SUMMIT, MO. 64082-2312 / USA
PHONE: 816-524-9666 FAX: 816-524-6983 www.billygoat.com
Poor air performance
Air intake or exhaust clogged.
Clear clog.
Self Propelled Units Only
Self propelled drive will not release Sticking belt idler arm. Belt fingers bent or
broken.
Check idler. Idler arm mounting screw may be
too tight or too loose. Check belt guide.
Replace if broken.
Machine is difficult to maneuver. Low tire air pressure. Inflate front and rear tires to correct pressure.
(See tire pressures on page 14.)
Abnormal vibration
Loose or out of balance impeller or loose
engine.
Check impeller and replace if required. Check
Engine.
Engine will not start
Stop switches off. Choke lever not in on
position. Out of gasoline. Bad or old gasoline.
Spark Plug wire disconnected. Dirty air
cleaner.
Check switches, choke, gasoline and oil. Check
for spark with an approved tester. Clean or
replace air cleaner. Contact qualified service
person.
Engine is locked, will not pull over.
Engine problem. Contact your nearest engine manufacturers
servicing dealer.
No self-propelling
Transmission not in gear. Operator's bail not
engaging belt or out of adjustment. Worn out or
broken chain. Broken or mispositioned belt.
Check transmission gear selection. Check clutch
cable adjustment, belt and chain (See page 14).
Noisy or broken chain
See Chain Adjustments on page 14.
No chain lubrication. Chain out of alignment or
over tensioned.
WARRANTY PROCEDURE
R
1803 S. Jefferson
P.O. Box 308
Lee's Summit,
MO 64063 / USA
Tel (816) 524-9666
Fax (816) 524-6983
Model Serial No.
Unit(Weight) Engine Power
lbs. kg kW rpm
115 dB
Should a Billy Goat Machine fail due to a defect in material and / or workmanship,
the owner should make a warranty claim as follows:
-The Machine must be taken to the dealer from whom it was purchased
or to an authorized Servicing Billy Goat
Dealer.
-The owner must present the remaining half of the Warranty
Registration Card, or, if this is not available, the invoice or receipt.
-The Warranty Claim will be completed by the authorized Billy Goat
Dealer and submitted to their respective Billy Goat Distributor for their
territory. Attention: Service Manager. Any parts replaced under
warranty must be tagged and retained for 90 days.
-The distributor service manager will sign off on the claim and submit
it to Billy Goat for consideration.
-The Technical Service Department at Billy Goat will study the claim
and may request parts to be returned for examination. Billy Goat will
notify their conclusions to the distributor service manager from whom
the claim was received.
-The decision by the Quality / Service department at Billy Goat to
approve or reject a Warranty claim is final and binding.
Note: To process a Warranty Claim, it is necessary to quote the Model & Serial
Number which are printed on the Billy Goat Serial Plate (See owner’s manual).