Filter
Top Products
Part No 350412 Form No F061311C
10
PR & OS Owner’s Manual
Troubleshooting
Problem Possible Cause Solution
Abnormal vibration. · Damaged or missing blades. Loose
handle bolts. Loose engine bolts
· Stop work immediately. Replace any
damaged or missing blades. Tighten all
loose nuts and bolts.
Engine stalls or labors when
raking
· Blades set too deep into ground. · Raise blades so that they just touch the
ground on a level surface
Engine will not start. · Stop switch off (Honda only). Throttle
in off position
· Check choke position.
· Out of gasoline or bad, old gasoline. · Check gasoline.
· Spark Plug wire disconnected. · Connect spark plug wire.
· Gas valve off. · Turn on gas valve.
· Dirty air cleaner. · Clean or replace air cleaner. Contact a
qualified service person.
Engine is locked, will not pull
over.
· Debris locked against reel, or drive
pulleys. Engine problem.
· Pull spark plug wire and remove debris.
Contact an engine servicing dealer for
engine problems.