Filter
Top Products
Part No 440270 Form No F041510A
9
FORCE BLOWER PUSH Owner’s Manual
ASSEMBLY
Figure A Figure B
1.Follow the steps in figures A and B, then securely tighten all hardware shown.
2.Connect spark plug wire.
The hardware for attaching the upper handle to the lower
is in the parts bag. Install upper handle (item 30), to
preassembled lower handle (item 28) by sliding the upper
over and down the outside of the lower handle. Using bolt
(items #36 and 71), washers (item #10) & lock nut (item
#11) to install upper handle to lower handle. Note: The
Pigtail bolt should go on the side that the pull start is on
and the open end should be facing down. Finish installing
the other side of the upper handle assembly using screw
and lock nut provided.
The throttle control will be attached to the throttle arm on
the engine and wrapped around the engine for shipping.
Unwrap and secure throttle control (item #31) to upper
handle with screws (item #17). Screws will already be
mounted in handle, simply remove and use to mount the
throttle control securing the cable with two Ty-wraps. The
Aim-and-Shoot
TM
is not attached, you will need to unroll
the cable and attach the ball end to the lever and seat the
cable end into the hole on the saddle clamp, with the
cable running through the slot. To keep the cable from
being damaged use three ty-wraps (item 74) to secure it
to the handle as shown making sure that the cable is not
rubbing against the tire. Note: the cable should be seated
properly in the saddle and should follow the contours of
the handle.
Two ½” open ended wrenches
One 5/16 open ended wrench
Good routing Bad routing