Filter
Top Products
Part No 441161 Form No F061509A
9
FORCE 6 BLOWER Owner’s Manual
ASSEMBLY
Figure A Figure B
1.Follow the steps in figures A and B, then securely tighten all hardware shown.
2.Connect spark plug wire.
The hardware for attaching the upper handle to the lower
can be found on the lower handle. Install upper handle
(item 24), to preassembled lower handles (item 25 & 26)
by sliding the upper over and down the inside of the lower
handle. Using bolt (item #12), washers (item #10) & lock
nut (item #11) to install upper handle to lower handle.
Finish installing the other side of the upper handle
assembly using screw and lock nut provided. The Aim-
and-Shoot
TM
is not attached, you will need to unroll the
cable and attach the ball end to the lever and seat the
cable end into the hole on the saddle clamp, with the
cable running through the slot. To keep the cable from
being damaged use three ty-wraps (item 61) to secure it
to the handle, as shown making sure that the cable is not
rubbing against the tire.
Attach the front tire using the hardware located on the
front wheel bracket. Use a block to raise the front end of
the unit off the ground. Insert the wheel spacer (item 17)
into the wheel and place in between the bracket. Finally
insert the bolt (item 20) through the bracket, wheel, and
spacer and secure with the nut (item 27)
Two ½” open ended wrenches
Two 9/16” Wrenches