Filter
Top Products
Part No. 360178 Form No. F121203A
Page 4 of 12
These labels should be included on your Aerator. If any of
these labels are damaged, replace them before putting this
equipment into operation. Item and part numbers are given to
help in ordering replacement labels.
Label Danger
Keep Hands
and Feet Away
Part No.400424
Label Hot Engine
Part No.400268
EXPLOSIVE FUEL
STOP ENGINE AND ALLOW TO
COOL BEFORE REFUELING.
400268
WARNING
14
15
INSTRUCTION LABELS
ENGINE LABELS
Label LIFT HERE
Part No.360187
13
CONTROLS
Set lever to choke position when
starting a cold engine
Label Instructions AE - Part No. 360191
WARNING
900327
Label Danger Guard
Part No.900327
Briggs & Stratton
'
'
'
..
Honda
OIL ALERT
ENGINE STOPS IMMEDIATELY.
WHEN OIL LEVEL LOW,
RUN
CHOKE
B & S ENGINE CONTROLSHONDA ENGINE CONTROLS
FUEL VALVE
CHOKE LEVER
RUN CHOKE
ON
OFF
THIS ENGINE EQUIPPED WITH
LOW OIL SENSOR, IF ENGINE WILL
NOT START, CHECK OIL LEVEL
Read and follow Operating
Instructions before running engine.
Gasoline is flammable. Allow engine
to cool at least 2 minutes before fueling.
Engines emit carbon monoxide,
DO NOT run in enclosed area.
LIFT HERE
WARNING
LIFT HERE WITH CAUTION
THE UNIT WEIGHS OVER 300 LBS.
Label Warning Unit Weight
Part No.360188
BEFORE STARTING, MAKE SURE:
TINE DEPTH CONTROL BAIL IS IN UP POSITION.
TO START, MOVE ENGINE STOP SWITCH TO "ON" AND PULL ROPE.
NOTE:
IT MAY BE NECESSARY TO USE THE ENGINE CHOKE IF
ENGINE IS COLD.
PUSH FORWARD ON TINE LIFT HANDLE TO ENGAGE TINES
IN GROUND.
PUSH FORWARD ON OPERATOR’S BAIL TO ENGAGE DRIVE AND
START AERATING.
DURING OPERATION PUSHING DOWN ON OPERATOR’S HANDLE
WILL MAXIMIZE CORING DEPTH.
RELEASE BAIL TO STOP UNIT.
NOTE:
ENGINE WILL CONTINUE TO RUN WITH BAIL DISENGAGED.
TO TURN UNIT, PULL BACK ON TINE LIFT HANDLE TO LIFT TINES
OUT OF GROUND. GRADUAL TURNS CAN BE MADE WITHOUT
LIFTING THE TINES.
WITH TINES UP, PUSH FORWARD ON OPERATOR’S BAIL TO
ENGAGE WHEELDRIVE FOR ASSISTED TURNING.
TO STOP ENGINE MOVE ENGINE STOP SWITCH TO "OFF".
ALL GUARDS ARE ATTACHED.
USE ONLY A QUALIFIED MECHANIC TO SERVICE THIS MACHINE.
INSPECT MACHINE BEFORE EACH USE AND REPLACE ANY
WORN AND DAMAGED PARTS.
CHECK ENGINE OIL DAILY.
PROPERLY SECURE EQUIPMENT BEFORE TRANSPORTING.
DISCONNECT SPARK PLUG WIRE BEFORE SERVICING UNIT.
FOR PREVENTATIVE MAINTENANCE
INSPECT AND CLEAN ENGINE AIR FILTER DAILY.
REPLACE AS NEEDED.
GREASE ALL BEARINGS AND CHECK GEAR REDUCTION
OIL LEVEL ON EVERY ENGINE OIL CHANGE.
ALWAYS:
360191
READ OWNERS MANUAL
BEFORE OPERATING
USE PERSONAL
PROTECTION EQUIPMENT
OPERATING INSTRUCTIONS
ENGINE SPEED CONTROL
Engine speed is set by using the throttle control lever,
located in the middle of the operators handle.
STOP
START
Increase
Speed
Decrease
Speed
STOP
START
Label Throttle Control
Part No.810656
STOP
START
Increase
Speed
Decrease
Speed
Throttle lever on handle
Throttle lever on handle