Filter
Top Products
POWER RAKE SEEDER BOX KIT-350395 AND 350397
Part No 350398 - 4 - Form No F102207B
REPLACING SLICING REEL
To replace the current reel with a slicing reel it will take approx.
20 min. and requires 1/2" and 9/16" sockets, and a ratchet with
extension. Use these instructions in conjunction with your
owner’s manual to identify all parts mentioned.
1. Wait for engine to cool and disconnect spark plug.
2. Close fuel valve on engine (if available)
3. Lean unit back onto lower handles and secure in place.
4. Remove (7) lock nuts (item 62 & 40) holding the belt and shaft
guards (item 21 & 22) in place. It is necessary to lower the height
adjust lever to reach the locknuts on the guards. Remove the
guards.
5. Remove the drive belt (item 9) by "walking" it out of the groove
on the reel pulley (item 2).
6. Remove the (4) lock nuts (item 60) and washers (item 68)
holding the bearings (item 23) to the frame of the unit.
7. The reel is now free from the machine. Slide the reel down
and out of the machine.
8. Assemble reel fig.2. After assembly reattach items in fig.1 in
the sequence shown. The shield bearing (item 30), pillow block
bearing (23), spacer (10), pulley (2), washers (68), nuts (60) can
be reused if they are not damaged. The lock washer twisted
tooth p/n 400502 (57), screwcap reel pulley p/n 8041050 (71),
and key 3/16” x 1” p/n 9201078 (42) must be replaced. Note:
pulley, key and spacer must be inserted only onto the side of the
reel that will be driven by the engine. The angled edge of the
blades should be facing the direction in fig. 1 to dig into the
ground otherwise the machine will not perform the proper
function. See rotation arrow.
9. Replace with fully assembled slicing reel.
10. Re-install the reel in reverse order of removal. Re-install the
guards in reverse order of removal. Tighten all hardware
securely.
11. Rotate the reel to make sure of even rotation.
12. Reattach spark plug and open fuel valve, if excessive
vibration occurs cease action immediately and check belt and
reel alignment and all hardware that might be loose.
item
PARTS
PR500 QTY
no. LIST
Part No.
57 LOCK WASHER 5/16 TWISTED TOOTH 800177 1
71 SCREWCAP 5/16 - 24 x 1" HCS GR. 5 400164 1
80 SHAFT SLICING WA 350142 1
81 BLADE SLICING REEL 350147 20
82 PLATE BLADE MTG. 350148 20
83 SPACER BLADE MTG. 350149 10
84 SPACER BLADE ASSY 350150 9
85 SCREWCAP 1/4-20 x 3/4, HCS ZP 8041004 40
86 NUT LOCK 1/4-20 8142004 40
87 COLLAR SPACER 350152 1
88 WASHER 0.937 x 1.750 x 0.119 350153 1
89 WASHER LOCK 7/8 INT. TOOTH 350154 1
90 NUT JAM 7/8-14 350155 1
Fig. 1
Fig. 2