Filter
Top Products
AquaSmart Wireless Termperature Module Manual
5
Figure 3 - How to open WTS
Initial Set-up
Remove power from the AquaSmart.
Snap the AquaSmart Wireless Module
(AWM) onto the COM Port (Figure 2) on the
side of the AquaSmart boiler temperature
control. Restore power to the AquaSmart
control.
Remove the internal cartridge containing the
1.
2.
3.
battery cell from the Wireless Temperature
Sensor (WTS). Press in the plastic tabs and
pull the cartridge out as shown in Figure 3.
Remove the plastic insert on the battery
terminal. Make sure battery is inserted
properly (see polarity mark on battery
holder).
Mount the WTS with the two screws
provided at your desired location. Mount the
sensor on any exterior wall (preferably on
the north face of the house), at least 6
inches below any vertical overhang, above
the snow line, out of reach of children, and
suffi ciently far away from any vents for them
not to affect temperature readings. Choose
a location protected from direct sunlight.
Use caution not to drill screws into any
existing electrical wiring or gas lines.
Verify operation:
Press the WTS button once (Figure 4).
The LED should fl ash fi ve times.
Using the AquaSmart’s display, navigate
to Screen 1 as shown in Figure 5, in the
Navigating the Display Menus
Section.
4.
5.
6.
a.
b.
Installation
Risk of Fire, Explosion, and
Burn Hazard.
Do not attempt to recharge,
disassemble, heat above 85°C, expose
to water, puncture, incinerate, or short-
circuit the battery.
Keep battery out of reach of children and in
original package until ready to use.
Mount with battery at bottom position only.
Failure to do so could expose the battery to
water.
Dispose of used batteries promptly.
y
y
y
y