Baldor 3KW-9KW Portable Generator User Manual


 
Always treat the electrical circuits as if they were energized.
Disconnect all leads plugged into the unit Prior to working on it.
Have the electrical circuits serviced only by qualified technicians.
Inspect wiring frequently and replace frayed, broken or poor leads.
Do not connect this unit to any building's electrical system unless you utilize an approved transfer switch or
the main service entrance switch has been disconnected and locked open.
Circuit overload protection must be provided in accordance with national electrical codes and local
regulations.
Check GFCI Receptacles monthly by using the "Test" and "Reset" buttons designed into them.
Depending on your application it may be mandatory to ground or not ground this unit to earth ground.
Comply with local electrical codes.
FOR GASOLINE OR DIESEL POWERED GENERATOR SETS
Operate the generator set on a level surface. If the generator set is tilted, fuel spillage may result.
Handle fuel with care. It is highly flammable. Use only clean, properly marked and approved safety
containers for refueling and storing fuel.
Stop the engine and allow it to cool before refueling.
Do not overfill the fuel tank. Only fill the tank to within 1/2" of the top of the tank to allow space for fuel
expansion.
If fuel is spilled, wipe it up carefully and wait until the fuel has dried before starting the engine.
Make sure the fuel cap is properly closed after refueling.
Never operate the generator set while smoking.
Never operate the generator set near an open flame.
Never store the generator set with fuel in the tank indoors or in an enclosed, poorly ventilated enclosure
where fuel fumes may reach an open flame, electrical spark or pilot light as on a furnace, water heater,
clothes dryer, etc.
When transporting over long distances or rough roads, drain the fuel tank to prevent leakage and spillage.
- iv -