4
English
Installation
Remove the dust cover (1).
Close the stops using a 4 mm Allen
wrench (2).
Cut the plaster shield so that it extends ¹⁄₁₆" - ⅛" outside
the surface of the nished wall.
Seal the wall around the plaster shield
using waterproof sealant.
Failure to seal the wall may result in
water damage.
Remove the ush insert and seals.
Flush the supplies:
Use extreme caution when carrying out
this step.
(1) Carefully open both stops.
(2) Allow the hot and cold supplies to ush.
() Close both stops.
1
3
2
closed
open
1.
2.
4 mm
4
4 mm
1.
2.
3.