Filter
Top Products
37
MOWER BELT REPLACEMENT
Mower Drive Belt Replacement - 33” Decks
1. Park the rider on a level surface. Disengage the PTO,
turn off the engine, set the ground speed control
levers to START/PARK, and set the parking brake
lever to ENGAGE. Remove the key.
2. Pull the idler pulley (C, Figure 57) to release belt
tension and remove the mower drive belt (B) from the
PTO pulley (A).
3. Remove the belt from the remaining deck pulleys.
Note:
The left rear threaded rod must be removed
from the mower in order to completely remove the
belt. Refer to the section entitled ‘Mower Deck
Removal and Installation’.
4. Install the new belt (B) as shown in Figure 57.
Mower Drive Belt Replacement - 42” Decks
1. Park the rider on a level surface. Disengage the PTO,
turn off the engine, set the ground speed control
levers to START/PARK, and set the parking brake
lever to ENGAGE. Remove the key.
2. Use the idler pulley arm (C, Figure 58) to release belt
tension and remove the mower drive belt (A) from the
PTO pulley (E).
3. Remove the belt from the remaining deck pulleys.
Note: It is not necessary to remove the mower deck.
4. Install the new belt (A) as shown in Figure 58.
WARNING
Before inspecting or servicing the mower, turn the
mower blades OFF, turn the ignition switch OFF,
and allow all moving parts to stop. Remove
ignition key, then disconnect the spark plug wire
and fasten it away from the spark plug.
E
F
F
D
C
B
A
Figure 58. Mower Belt Routing - 42” Decks
A. Mower Drive Belt
B. Right Arbor Pulley
C. Idler Pulley Arm
D. Left Arbor Pulley
E. Engine PTO Pulley
F. Backside Idler Pulley
A
B
C
D
Figure 57. Mower Belt Routing - 33” Decks
A. Engine PTO Pulley
B. Mower Drive Belt
C. Back-Side Idler Pulley
D. Stationary Idler Pulley
E. Arbor Pulley
E
Not for
Reproduction