Filter
Top Products
4
www.atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
2. LINK LED: When the device detects the display and sends the signal out the Link LED will illuminate.
3. SYNC LED: When the device detects the source signal the SYNC LED will illuminate.
4. Power LED: The LED will illuminate in green when powered on and red when in standby mode.
5. Reset button: Press this button to reset your EDID after each EDID setting.
2. Rear Panel
1. USB OUT: Connect a USB A type cable to the display monitor or PC/notebook for audio & USB signal
bypass. There is only 1 x USB by-pass, all the other displays USB connections should be connected directly
to the computer.
2. USB IN: Connect a mini USB cable from your PC/notebook for USB signal sending.
3. MINI-DP OUT 1 & 2: Connect the MDP cable or MDP to DP cable to your MDP/DP input display for dis-
playing a single source on two screens simultaneously.
4. MINI-DP IN: Connect the MDP cable or MDP to DP cable from the MDP/DP source for signal sending.
1 2 3 4