Filter
Top Products
Page 4 of 8
Date: February 26, 2014 No. C-2014R
Replaces C-2014
6. Replace chute crank and secure with spring clip pin.
• If Equipped: Reconnect remote deflector cable to control lever.
7. Replace gear cover on top of chute pedestal.
8. Run in the attachment belt(see Run-in Attachment Belt on page 4).
9. Replace belt cover and tighten hardware.
RUN-IN ATTACHMENT BELT
1. Start unit in a well-ventilated area.
2. Engage attachment clutch lever and run attachment for about 15 minutes.
3. Stop unit, wait for all moving parts to stop, and remove spark plug wire.
4. Adjust clutch idler (see Attachment Clutch/Brake Adjustment on page 5).
Figure 2
5
3
2
1
6
7
4
1. Traction Belt Idler
2. Traction Drive Belt
3. Engine Sheave
4. Belt Finger
5. Attachment Drive Belt
6. Attachment Pulley
7. Attachment Idler Nut
8. Attachment Belt Idler
8
Figure 3
1. Belt Finger
2. Attachment Drive Belt
3. Swing Gate Pivot Bushing
1
2
1/8" (3.2 mm)
(Maximum)
3